Gaggia RI9305/01 User Manual download pdf (Page 28)

• 28 •• 28 •

Blinking

• Switch the power button to “I” to turn

the machine on.

Circuit Priming

• To prime the water circuit, place a

container under the steam wand (Pan-

narello, if supplied).

• Make sure the selector switch is in the

“ ” position; if this is not the case, set

it to that position.

• To turn the machine on simply press the

“STAND-BY” button.

• The blinking icons shown in the picture

warn that the circuit must be primed.

Note: Before starting the

machine for the first time,

and after long periods of inactivity,

prime the water circuit.

• The “STAND-BY” button blinks.

Blinking

Slow blinking

Cyclic blinking

Steady on

• Turn the selector switch clockwise to set

it to the “

” position. The machine

starts the automatic priming of the

circuit by letting out a preset quantity

of water through the Pannarello.

Once the circuit has been primed, the

icons shown in the  gure will start to

blink.

Turn the selection knob back to its

central position “

”.

• The icons displayed blink slowly to

show that the machine is warming up.

When warm-up is complete,

the machine performs a rinse

cycle of the internal circuits.

During this phase, the icons displayed

will blink in sequence.

• When the operations described above

are completed, the icons on the display

will illuminate.

The display will appear as

shown to the side. The dis-

played aroma is the factory setting

when the machine is switch on for

the  rst time, or it is the same as the

aroma that was selected for the last

brewed co ee.

The machine is then ready to brew

beverages.

• To brew coffee, dispense hot water or

steam, and properly use the machine,

carefully follow the instructions provided.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 87 88

Comments to this Manuals

No comments